Workplane by Facet

In this Task 

A Workplane will be applied to the back rectangular face of the extruded rectangle.

Before you Start 

The view is set to Isometric North East.

Take Note 

Take care when placing the Workplane on this facet.  The Workplane should be placed on the outer wall of the solid.

Workplane by Facet

Ribbon : Workspace | Workplanes | WorkPlane | by Facet

Palette : 3D Model | Workplane | Workplane by Facet

Right click in the Editor | Workplane by Facet

This workplane feature applies a workplane to a selected facet (flat surface) of a 3D object.The Page Up and Page Down keys can be used to cycle between the available facets of the solid.

 

Take care when placing the Workplane on this facet.  The Workplane should be placed on the outer wall of the solid, shown below.

View the model from a different viewpoint to check the position of the Workplane, shown below.