Task Drawing & Worksheet

RESOURCES Download and save the sample drawing to your local drive.(A sample of the finished drawing is available in the Blocks Palette)

 

Activity Overview

During this session you will learn how to :

• Draw a small plate shown in the illustration above using various Draw, Modify and Zoom tools.
• Dimensions will also be inserted onto the drawing.
• A drawing layout will be created suitable for printing the drawing.

Introducing

The following tools will be used during this Session :

• Rectangle
• Lines & Parallel Lines
• Circles
• Fillet & Chamfer
• Meet 2 Lines
• Line Length
• Trim
• Center Point Marks
• Object Properties
• Snap Modes
• Dimensions
• Drawing layout/print
• Block Attributes

INFORMATION

• This Session contains all the instructions on each page to complete the drawing.
• Each Task of this Session contains animation in the form of a movie.
• The instructions flow from one task to the next and the illustrations are contained in a storyboard manner.
• It is recommended that you save your finished drawing to a secure location as it will be used again at a later stage of this Module.
• This Session uses the TurboCAD Ribbon workspace and menu options.

Estimated Duration

• Approximately 30 minutes drawing time. Total session duration may vary.

Task Videos

• A video is provided for each individual Task of this Session, however a full session video is provided below.